Alistair's Eccentric Bottom Bracket Heat Sink
Alistair made this heat sink to reduce bottom bracket distortion while brazing. He made it on his lathe and then came over to use the bandsaw to cut it in half.
You can see his photos over here:
http://www.flickr.com/photos/duncancycles/sets/72157609171987407/
Read MoreYou can see his photos over here:
http://www.flickr.com/photos/duncancycles/sets/72157609171987407/
1 / 3
We put a cheap drill press vise in the bandsaw vise to hold the heat sink. The tubing on the right side of the vise is a stop block for the bandsaw to keep it from cutting into the vise.
alistairbandsawbicycleeccentric bottom bracketframebuildingheatsink
- No Comments