Frame Alignment and Fixturing Table
Using a Bridgeport 9x36 milling table, bits of 80/20, and homemade parts to construct a bicycle frame tacking fixture and alignment jig.
The milling table was Brandon Ives idea and it seems like it'll be a good solution. I bought this one used for $40 (the freight cost 3x that). It's flat and the t-slots are very helpful for fixturing items in place.
Read MoreThe milling table was Brandon Ives idea and it seems like it'll be a good solution. I bought this one used for $40 (the freight cost 3x that). It's flat and the t-slots are very helpful for fixturing items in place.
1 / 13
The table and items that I've built so far sitting on top of it. None of the items are complete except for the bottom bracket post on the far right.
The stand for the table was the stock stand for my tablesaw. I reconfigured it to match the table dimensions. The casters suck (and will be replaced), but otherwise the stand works well.
- No Comments