photos.alexwetmore.org

  • Home
  • Browse
  • Alex's Blog
  1. Bicycles
  2. Fixtures

Arctos Clone Frame Fixture

Read More
The lower head tube is setup be parallel with these marks right on the pivot
23 / 35

The lower head tube is setup be parallel with these marks right on the pivot

  • This is setting the X distance from the BB to the head tube.  The scribed mark in the middle of the ink is centered with the BB.
  • This is the bottom of the head tube adjuster plate.  That scribed mark is centered under the lower head tube cone.
  • The lower head tube is setup be parallel with these marks right on the pivot
  • The chainstay length is easy to read directly.
  • The rear tower assembly.  Using 80/20 1530 extrusion here saved me from drilling very long holes for the locking levers.  It is much easier to make the little end caps.
  • The whole fixture.
  • The STA tower assembly pivots around the BB shell (so adjusting the STA angle does not move the BB shell).  The 3 outer handles move this assembly left and right, the one in the slot is for adjusting the seat tube angle.  There is a scale for reading off the seat tube angle on the other side.
  • The HTA tower assembly pivots around the bottom of the head tube.  The blue bolt locks the angle, the black handle allows the plate to move up and down.
  • Red measurements are used to setup the jig.  Blue ones are used to miter tubing.
  • Untitled video
  • Backplate for the STA adjustment on my fixture.  The adjustment plate rides in the slot on the backplate.  The threaded hole in the middle is where the locking handle goes.
  • Adjustment plate for the STA on my jig.  This shows the back side of it.  The two brass pins ride in the slot of the backplate.
  • I'm installing the adjustment plate and you can see the brass pins going into the slot.
  • Everything but the locking handle.  You can see how the locking handle goes into that threaded hole.
  • Fully assembled.

New Galleries

  • Benno Carry-On

    Benno Carry-On

  • Grizzly G3102 For Sale

  • Benno Carry-On/Boost rack

    Benno Carry-On/Boost rack

  • Emco Compact 10 Lathe

    Emco Compact 10 Lathe

  • Benno Carry-On Rear Rack

    Benno Carry-On Rear Rack

  • Family Photos Summer 2018

    Family Photos Summer 2018

  • Our Wedding!

    Our Wedding!

  • Logan and Dave's Wedding

    Logan and Dave's Wedding

  • Ballard Cup 2 -- June 25 2018

    Ballard Cup 2 -- June 25 2018

  • RttS 2018 tides

    RttS 2018 tides

  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2023 SmugMug, Inc.